Kurzweil FORTE SE Musician's Manual page 232

Multi Edit Mode
CCTLS (CCs/Continuous Controllers) Page
Curve
Entry Position
Exit Value
Controller
The Controller parameter allows you to assign any of the Forte SE's continuous controllers
(sliders, mod and pitch wheels, expression pedal and pressure) to control a program specific
parameter or MIDI controller number for the currently selected Zone.
First, use the Channel/Layer/Zone buttons to the left of the display to select the desired zone
that you wish to assign a controller for. Next, on the Multi CCs page, use the navigation
buttons to select the "Controller" field, hold the Enter button and then move any of the
Forte SE's continuous controllers. This will select that controller and display its available
parameters. (You can also scroll through the list of controllers on the Control page by
selecting the Controller field with the navigation buttons and using the Alpha Wheel or the
Value buttons to scroll through the list.) If a pedal is selected which has a pedal override
enabled in Global mode, a message "(Global Override)" will display when that pedal is
viewed to remind you that the Global mode pedal override settings are being used instead of
the Multi mode pedal settings.
Mode
Continuous Controllers have two modes: Off, or MIDI CC.
With a value of Off, the controller is disabled for this zone.
With a value of MIDI CC, the controller has the ability to transmit MIDI control messages.
Dest (Destination)
Use the Destination parameter to assign the Forte SE continuous controllers (Sliders,
Wheels, Expression Pedal, or pressure) to control Program parameters or send MIDI
continuous controller messages (CCs) to external MIDI gear. If a controller number (MIDI
CC number) is assigned to a parameter in the Program of the current Zone, the parameter
11-14
Parameter
Linear, Compress, Expand, Cross-
fade, Bump, Rvrs Linear, Rvrs
Expand, Rvrs Compress, Rvrs
Crossfade
None, 0 to 127
None, 0 to 127
FORTE SE CONTINUOUS
Mod Wheel
Pressure
CC Pedal
Pitch Wheel Up
Pitch Wheel Down
Range Of Values
CONTROLLERS
Slider A
Slider B
Slider C
Slider D
Slider E
Default Value
Linear
-
-
Slider F
Slider G
Slider H
Slider I