Lexmark MS810 User Manual page 77

Using MS810n, MS810dn, MS811n, MS811dn, MS812dn, MS817n, MS817dn, MS818dn
Use
On
Off
3
Press .
Adjusting Sleep mode
1
From the control panel, navigate to:
> Settings >
2
In the Sleep Mode field, select the number of minutes the printer is idle before it enters Sleep mode.
3
Apply the changes.
Using Hibernate mode
Hibernate is an ultra‑low‑power saving mode.
Notes:
•
Three days is the default amount of time before the printer enters Hibernate mode.
•
Make sure to wake the printer from Hibernate mode before sending a print job. A hard reset or a long
press of the Sleep button wakes the printer from Hibernate mode.
•
If the printer is in Hibernate mode, then the Embedded Web Server is disabled.
1
From the control panel, navigate to:
> Settings >
2
Select Press Sleep Button or Press and Hold Sleep Button, and then press
3
Press Hibernate >
> Settings > > General Settings >
> Settings > > General Settings >
.
To
Reduce printer noise.
Notes:
•
Print jobs process at a reduced speed.
•
Printer engine motors do not start until a
document is ready to print. There is a short delay
before the first page is printed.
•
The alarm control and cartridge alarm sounds are
turned off.
•
The printer ignores the Advance Start command.
Use factory default settings.
Note: This setting supports the performance
specifications of the printer.
> Timeouts > > Sleep Mode >
.
77