Checking The Swingarm; Checking The Routing Of The Throttle Cable; Checking The Rubber Grip - Husqvarna TC 85 2017 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.39

Checking the swingarm

11.40

Checking the routing of the throttle cable

Warning
Danger of accidents The throttle cable may slip out of the guide if routed incorrectly.
The throttle slide will then no longer be closed and the speed can no longer be controlled.
–
Make sure that the throttle cable routing and the play in throttle cable complies with the specification.
11.41

Checking the rubber grip

–
Check the swingarm for damage, cracking, and deformation.
» If the swingarm shows signs of damage, cracking, or deformation:
–
Change the swingarm.
S00497-10
Preparatory work
–
Remove the seat. (
–
Turn tap handle
(Figure S00484-10
–
Remove the fuel tank.
Main work
–
Check the routing of the throttle cable.
The throttle cable must be routed to the carburetor on the left side above the
fuel tank bracket.
» If the throttle cable is not routed as specified:
–
Correct the routing of the throttle cable.
E00285-01
Finishing work
–
Install the fuel tank.
–
Mount the seat. (
–
Check the rubber grips on the handlebar for damage and wear and to ensure they
are firmly seated.
» If a rubber grip is damaged, worn or loose:
–
Change and secure the rubber grip.
Grip adhesive (00062030051) (
401197-01
Info
Always change a damaged swingarm. Repair of the swingarm is
not authorized by Husqvarna Motorcycles.
p. 41)
 on the fuel tap to the OFF position.
p. 12)
( p. 45)
( p. 46)
p. 41)
p. 90)
51