Checking The Frame - Husqvarna TC 85 2017 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.38

Checking the frame

–
Check the chain sliding piece for wear.
» If the lower edge of the chain pins is in line with or below the chain sliding
piece:
–
Change the chain sliding piece.
–
Check that the chain sliding piece is firmly seated.
» If the chain sliding piece is loose:
–
Tighten the screw on the chain sliding piece.
Guideline
Screw, chain sliding piece
M00328-10
–
Check the chain guide for wear.
Info
Wear can be seen on the front of the chain guide.
» If the dark part of the chain guide is worn:
–
Change the chain guide.
401585-01
–
Check that the chain guide is firmly seated.
» If the chain guide is loose:
–
Tighten the fitting on the chain guide.
Guideline
Remaining screws, chassis
Remaining nuts, chassis
E00228-10
Finishing work
–
Remove the motorcycle from the lift stand. (
–
Check the frame for cracks and deformation.
» If the frame exhibits cracks or deformation due to a mechanical impact:
–
Change the frame.
401542-01
Info
Always replace a frame that has been damaged due to a mechan-
ical impact. Repair of the frame is not authorized by Husqvarna
Motorcycles.
M8 15 Nm
(11.1 lbf ft)
M6 10 Nm
(7.4 lbf ft)
M6 10 Nm
(7.4 lbf ft)
p. 32)
50