Installing The Fork Legs; Removing The Fork Protector - Husqvarna TC 85 2017 Owner's Manual

11 SERVICE WORK ON THE CHASSIS
11.6

Installing the fork legs

11.7

Removing the fork protector

Main work
–
Position the fork legs.
Bleeder screws
Info
The second milled groove (from the top) must be flush with the top edge of
the upper triple clamp.
E00197-10
–
Tighten screws
Guideline
Screw, top triple clamp
–
Tighten screws
Guideline
Screw, bottom triple clamp
E00201-11
–
Connect the brake line at the start number plate.
E00203-10
–
Position the brake caliper with spacers and fit and tighten screws
Guideline
Screw of brake caliper
–
Position the brake line and clamp. Mount and tighten screws
E00202-10
Finishing work
–
Install the front wheel.
–
Remove the motorcycle from the lift stand. (
–
Remove screws
–
Remove screws
–
Remove screws
E00256-10

are positioned toward the front.

.
M8

.
M8
M8
( p. 65)

. Take off the clamp.

on the left fork leg. Take off the fork protector.

on the right fork leg. Take off the fork protector.
20 Nm (14.8 lbf ft)
15 Nm (11.1 lbf ft)
 .
25 Nm Loctite ® 243™
(18.4 lbf ft)

.
p. 32)
34