Command Examples; Vlan Translation And Aggregation Commands - ZyXEL Communications IES4005M User Manual

Chapter 25 VLAN

25.4.1 Command Examples

This example enables port 4 of the line card in slot 2 and also enables VLAN TLS with S tag VLAN
100 with S priority bit 0.
ras# config
ras(config)# interface dsl 2/4
ras(config-interface-dsl-2/4)# active
ras(config-interface-dsl-2/4)#
ras(config-interface-dsl-2/4)# exit
ras(config)# exit
ras# show vlan 100
S tag TPID: 8100 (hex)
single tag mode: ctag
VLAN ID 0000000001111111111222222222233333333334444444444555555555566666
100 1234567890123456789012345678901234567890123456789012345678901234
=========================================================================
slot 2:---V------------------------------------------------------------
slot 3:----------------------------------------------------------------
slot 4:----------------------------------------------------------------
slot 5:----------------------------------------------------------------
enet :--
ras#

25.5 VLAN Translation and Aggregation Commands

VLAN translation changes the VLAN tag on traffic received from a subscriber port to another VLAN
ID for the service provider's network. This makes it easier to deploy customer-specific VLANs
because all the CPE devices can use the same VLAN configuration. You only need to configure VLAN
translation on the IES to use unique VLAN IDs for each subscriber's traffic. VLAN aggregation lets
the IES translate two or more different UNI VLAN IDs on a DSL port to a NNI VLAN ID.
See Section 25.1.4 on page 181
examples.
The following table describes commonly used parameter notation for these commands.
Table 130 VLAN Translation and Aggregation Command Parameters
NOTATION
svid
cvid
vpi
vci
This table describes the commands.
Table 131 VLAN Translation and Aggregation Commands Summary
COMMAND
interface dsl <slot/portlist>
exit
188
vlan tls svlan 100 spbit 0
for more on VLAN translation and aggregation and command
DESCRIPTION
The SVID (Service provider VLAN ID) 1-4093.
The CVID (Customer VLAN ID)
The VPI (Virtual Path Indicator) 0-255.
The VCI (Virtual Channel Indicator) 32-65535.
DESCRIPTION
Enters the sub-command mode for configuring the specified DSL ports. C
Leaves the DSL port configuration.
1-4093.
M P
13
C 13
IES4005M User's Guide