ZyXEL Communications IES4005M User Manual page 84

Chapter 11 Management
This table describes the commands.
Table 58 Alarm Commands Summary
COMMAND
show alarm current [severity <severity>] [alarm
<alarm>] [condition <condition>] [start-date
<month>/<day>/<year>] [end-date <month>/<day>/
<year>] [forward|reverse] [detail] [indexes]
clear alarm current [condition <condition>
indexes <index1>/<index2>/<index3>]
show alarm history [severity <severity>] [alarm
<alarm>] [condition <condition>] [start-date
<month>/<day>/<year>] [end-date <month>/<day>/
<year>] [forward|reverse] [detail]
clear alarm history [severity <severity>] |
[alarm <alarm>] | [condition <condition>]
alarm definition alarm <alarm> condition
<condition> severity <severity> [syslog-
facility <facility>] [target <target>]
[clearable]
show alarm definition [alarm <alarm>] [condition
<condition>] [severity <severity>] [target
<target>]
alarm cutoff
show interface dsl <slot/portlist> alarm line-
control
show interface dsl <slot/portlist> alarm
notification-severity
interface dsl <slot/portlist>
exit
alarm line-control
no alarm line-control
alarm line-control interval <interval>
84
DESCRIPTION
Displays current alarms.
indexes displays alarm indexes information
Clears all clearable current alarms or alarms
with the specified condition code and indexes
condition: check for alarm definition table
for allowed condition
index1: target alarm index1, check for
indexes of alarm current table
index2: target alarm index2, check for
indexes of alarm current table
index3: target alarm index3, check for
indexes of alarm current table
Displays alarm history.
Clears historical alarms with the specified
severity or specified alarm or specified
condition or all severities.
Configures the specified alarm definition.
condition: check the alarm definition table
for allowed conditions or condition codes
clearable: alarm is clearable
Displays the alarm definition table.
Issues an alarm cutoff to stop signaling an
alarm.
Displays the time interval settings for
reporting alarms when you enable alarm line-
control on the specified DSL ports.
Displays the minimum severity level to send
out alarm notifications (SNMP trap and
SYSLOG) on the specified DSL ports.
Enters the sub-command mode for configuring
the specified DSL ports.
Leaves the DSL port configuration.
Has the IES report alarms for the ports at
regular intervals instead of immediately.
Turns off interval-based reporting of alarms so
the IES reports alarms immediately.
Sets the time interval (10-600 seconds) the
IES uses for sending alarms about these
ports. This applies when you enable alarm
line-control on these ports.
M P
E 1
E 13
E 1
E 13
C 13
E 1
E 13
E 1
E 1
C 13
C 13
C 13
C 13
C 13
IES4005M User's Guide