Wlan Module - HP ZBook 17 G4 Mobile Workstation Maintenance And Service Manual

WLAN module

Description
Intel Dual Band Wireless-AC 8265 3rd Gen Intel 802.11ac, Dual Band, 2x2 Wi-Fi + Bluetooth 4.2
Intel Dual Band Wireless-AC 8265 3rd Gen Intel 802.11ac, Dual Band, 2x2 Wi-Fi + Bluetooth 4.2 (non-
vPro)
CAUTION:
authorized for use in the computer by the governmental agency that regulates wireless devices in your
country or region. If you replace the module and then receive a warning message, remove the module to
restore device functionality, and then contact technical support.
Before removing the WLAN module, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Service door (see
b. Battery (see
c. Base enclosure (see
d. Hard drive(s) and internal frame (see
e. Solid-state drive(s) (see
Remove the WLAN module:
1. Disconnect the WLAN antenna cables (1) from the terminals on the WLAN module.
NOTE:
The WLAN antenna cable labeled "2" connects to the WLAN module "Aux" terminal labeled "2".
2. Remove the Phillips screw (2) that secures the WLAN module to the system board. (The WLAN module
tilts up.)
40 Chapter 5 Removal and replacement procedures for Customer Self-Repair parts
To prevent an unresponsive system, replace the wireless module only with a wireless module
Service door on page
Battery on page
Base enclosure on page
Solid-state drives (M.2) on page
The WLAN antenna cable labeled "1" connects to the WLAN module "Main" terminal labeled "1".
30).
31).
33).
Hard drive(s) and internal frame on page
Spare part number
910264-852
918855-852
33).
38).