Using #77 Instant Activation Mode; Relay Commands; Arm/Disarm Commands - Honeywell VISTA-128BPT User Manual

Section 28: Using #77 Instant Activation
• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
The #77 Instant Activation Mode is used to activate outputs, bypass zones, etc. immediately upon
exiting the #77 Mode. The actions that may be activated are relay commands, arm/disarm
commands, zone bypassing commands, and open/close access conditions.
R e l a y C o m m a n d s
Action Code
01
02
03
04
05
06
07
08
09
10
∗ Check with your installer for the amount of time.
A r m / D i s a r m C o m m a n d s
Activation times 1 (Beginning), 2 (End), 3 (During) are the only valid choices for automatic arming and
disarming functions.
"During" can be used to arm or disarm the control for a specific time only. For example, if "during" is
selected with Arm-STAY, the system will automatically Arm-STAY at the beginning of the window and
automatically disarm at the end of the window.
Action Code
20
21
22
23
24
25
26
Relay On
Relay Off
Relay Close for 2 seconds
Relay Close XX minutes ∗
Relay Close YY seconds ∗
Relay Group On
Relay Group Off
Relay Group Close for 2 seconds
Relay Group Close XX minutes ∗
Relay Group Close YY seconds ∗
Arm-STAY
Arm AWAY
Disarm
Force Arm STAY (Auto-bypass faulted zns)
Force Arm AWAY (Auto-bypass faulted zns)
Arm INSTANT
Arm MAXIMUM
51
Mode
Action Specifier
Relay #
Relay #
Relay #
Relay #
Relay #
Relay Group #
Relay Group #
Relay Group #
Relay Group #
Relay Group #
Action Specifier
Partition(s)
Partition(s)
Partition(s)
Partition(s)
Partition(s)
Partition(s)
Partition(s)