Honeywell VISTA-128BPT User Manual page 61

4. Scroll through the categories.
Use the [3] & [1] keys (for next and previous categories respectively) to display the
categories of events.
Press [8] to select a category and display the first event. Press [8] again for each
subsequent event.
Example: Shows burglary alarm occurred in zone 3 (C003) of partition 1 (P1), at 12:02AM
on January 1.
P1 01/01 12:02AM
BURGLARY C003
After the last event has been displayed, the END OF EVENT LOG message appears for a
few seconds, then the system automatically displays the RECENT/COMPLETE mode select
screen again (see step 2).
5.
To EXIT the Event Log Press [∗] at any time.
ALARM EVENT LOG
TYPE CCC UUU
ALARM EVENT LOG
Displays time and date for zones that has either caused an alarm or has been restored in the
selected partition.
CHECK EVENT LOG
Displays time and date for zones that has caused a trouble or supervisory condition in the
selected partition.
BYPASS EVENT LOG
Displays time and date for zones that has been bypassed in the partition.
OPEN EVENT LOG
Displays time, date and user number or 6-character descriptor for the user, if programmed,
for each arming and disarming of the system for the partition selected.
SYSTEM EVENT LOG
Displays time and date for system problems, such as AC Loss, low battery, etc., regardless of
partition.
ALL EVENT LOG
Displays all categories of events in chronological order.
6. See your Installer for additional information concerning the event log.
Event Log Procedures (cont'd)
Typical Event Log Display
55