Device Functions - Siemens SIRIUS 3RW44 User Manual

ID
Bit
Byte
No.
2
353 6 Quick stop active
3
6 Reserved = 0
4
361 6 Trip reset carried out
5
362 6 Trip reset not possible
6
363 6 Maximum pointer deleted
7
317 6 Electronics supply
voltage too low
Communication
0
303 7 Bus error
1
356 7 CPU/master STOP
2
357 7 Automatic operating mode
3
358 7 Manual bus operating mode
4
359 7 Manual operation local operating
mode
5
7 Reserved = 0
6
360 7 Connection break
in manual operation local operating
mode
7
355 7 Process image error
Parameter
0
364 8 Parameterization active
1
365 8 Incorrect parameter value
2
366 8 Parameter changes not permissible
when ON
3
368 8 Parameterization disable CPU/
master active
4-7
8 Reserved = 0
SIRIUS 3RW44 manual
GWA 4NEB 535 2195-02 DS 06
Signal bit
PROFIBUS DP Communication Module
E
Meaning/Acknowledgment
*)
No.
E26, The motor is switched off due to a quick stop.
E24 The signal bit is deleted when the cause for the switch-
off has been remedied and acknowledged via "Trip
reset".
— The signal bit is deleted by update or "Trip reset" in
ready state.
— Cause for the switch-off is still present.
The signal bit is deleted by update (new "Trip reset") or by
"Trip reset" in ready state.
— The signal bit is always deleted after acknowledgement
with "Trip reset".
— The signal bit is deleted automatically when the cause
for the switch-off is remedied.
— Watchdog function of the DP interface has elapsed.
The signal bit is updated continuously.
— PLC program no longer processed.
The signal bit is updated continuously.
— Automatic (PLC-controlled).
The signal bit is updated continuously.
— Manual operation via field bus (O&M controlled).
The signal bit is updated continuously.
— Manual operation via local device interface
(O&M controlled). The signal bit is updated continuously.
—
— The associated communication connection was
interrupted during manual operation. The signal bit is
updated continuously.
E26 Process image of the outputs contains impermissible bit
E24 combinations. The signal bit is automatically deleted when
the cause for the switch-off is remedied.
— The signal bit is updated continuously.
E16 The signal bit is always deleted following an
acknowledgement with "Trip reset" or after valid
parameters have been received.
E24 Causes a switch-off during starting.
— Parameter change attempted while motor running or
during the affected device function, causing a switch-off.
The signal bit is always deleted following an
acknowledgement with "Trip reset" or after valid
parameters have been received.
— The signal bit is updated continuously.
The soft starter ignores the parameters from the PLC.
—
8-51