Siemens SIRIUS 3RW44 User Manual page 158

Soft starter
Hide thumbs Also See for SIRIUS 3RW44:
Table of Contents

Advertisement

PROFIBUS DP Communication Module
Error types
E
Error type
No.
00001:
E1
Short-circuit
00100:
E4
Overload
00101:
E5
Overtemperature
00110:
E6
Line breakage
00111:
E7
Maximum limit
value exceeded
01000:
E8
Minimum limit
value undershot
01001:
E9
Error
10000:
E16
Parameter error
10001:
E17
No supply or load
voltage
11000:
E24
Actuator switch-
off
11010:
E26
External error
Table 8-14: Error types
8-34
The diagnosis message is reported on channel 0.
Meaning/Cause
• Short-circuit in the temperature sensor
• Overload of the temperature sensor
• Overload of the thermal motor model
• Overload of the contact block
• Wire break in the temperature sensor
• I
limit value exceeded
e
• I
limit value undershot
e
• Internal error/device error
• Contact block defective
• Incorrect parameter value
• Electronics supply voltage too low
• No supply voltage at the contact block
• No line voltage
• Switch-off due to overload
• Switch-off due to residual current
• Switch-off due to asymmetry
• Switch-off due to ground fault
• Overload of the sensor supply
• Process image error
Delete signal bit / Acknowledgement
The signal bit is deleted automatically when
the cause for the switch-off has been
remedied and acknowledged via "Trip reset".
The signal bit is updated continuously.
The signal bit is deleted automatically when
the cause for the switch-off has been
remedied and acknowledged via "Trip reset".
The signal bit is updated continuously
The signal bit can be deleted when the cause
of the error has been remedied by
• Switching the supply voltage off/on
• Issuing the "Restart" command if possible
The signal bit is always deleted after
acknowledgement with "Trip reset".
The signal bit is deleted when the cause for
the switch-off has been remedied or
acknowledged automatically.
The signal bit is always deleted after
acknowledgement with "Trip reset".
Additional acknowledgement in combination
with other errors.
The signal bit is always deleted after
acknowledgement with "Trip reset".
GWA 4NEB 535 2195-02 DS 06
SIRIUS 3RW44 manual

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents