Getting Started; Replacing The Battery; Adjusting The Eyepiece; Operational Summary - Bushnell TOUR V4 Manual

GETTING STARTED

REPLACING THE BATTERY

Your TOUR V4 comes with a battery already installed, so it's ready to use right away. To replace the
battery, remove the battery cap by lifting the battery cap tab and then rotating counter clockwise. Insert a
CR-2 3-volt lithium battery into the compartment negative end first, then replace the battery cap.
NOTE: It is recommended that the battery be replaced at least once every 12 months.
Low Battery Indicator: If " " is displayed within the in-view readout, this means "low battery" or
battery charge is getting low and the 3-volt lithium battery should be replaced.

ADJUSTING THE EYEPIECE

Your TOUR V4 is constructed with an adjustable eyepiece (+/- 3 Diopter Adjustment) that allows one
to focus the LCD display relative to the image. Simply rotate the eyepiece until the reticle and object
distanced to are both in focus to your eye.

OPERATIONAL SUMMARY

While looking through the 5x eyepiece, depress the POWER/FIRE button once to activate the in-view
Liquid Crystal Display (LCD). Place the aiming circle (located in the center of the field of view) upon a
target at least 5 yards away, depress and hold the POWER/FIRE button down until the range reading
is displayed near the bottom of the in-view display. Crosshairs surrounding the aiming circle indicate
that the laser is being transmitted. Once a range has been acquired, you can release the POWER/
FIRE button. The crosshairs surrounding the aiming circle will disappear once the POWER/FIRE button
has been released (i.e. the laser is no longer being transmitted). Note: Once activated, the LCD will
remain active and display the last distance measurement for 10 seconds. You can depress the power
6