How To Measure The Range And Bearing Between Two Targets; How To Off-Center The Picture; Heading Line - Furuno TZT9 Operator's Manual

6. RADAR
6.8 How to Measure the Range and Bearing Between
Two Targets
You can measure the range and bearing between any two targets with the [Measure]
menu.
1. Select the center of the target A to display the pop-up menu.
2. Select [Measure].
3. Select the center of the target B. A dashed line runs between the target A and the
target B. The range and bearing between the targets A and B are shown.
Target A
4. Select [Cancel Ruler] at the top right-hand corner of the screen to erase the indi-
cation.
6.9

How to Off-center the Picture

You can off-center your position to expand the view field without selecting a larger
range scale. The position can be off-centered in the bow, stern, port or starboard di-
rection, but not more than 75% of the range in use.
Pan the radar display by dragging with a finger. To return your ship to the center of the
screen, select [Center Radar] at the top right-hand corner of the screen.
330
320
310
300
290
280
270
260
250
240
230
220
210
Normal picture
6.10

Heading Line

The heading line indicates your heading in all orientation modes. This line connects
between your position to the outer edge of the radar display. The line is at zero de-
grees on the bearing scale in the head-up mode. The orientation of the line changes
in the north-up mode with the movement of your ship. If it is hard to identify the echoes
on the heading line, you can hide the heading line and range rings for a few seconds.
Select [Hdg Ln Off] from the RotoKey menu to activate this function.
6-10
30
40
50
60
70
80
90
100
110
120
130
140
150
0.876NM 0.876NM
Range and bearing
76.4°M 76.4°M
M: Magnetic
Target B
0
350
340
330
320
310
300
290
280
270
260
250
Picture off-centered in stern direction
10
20
30
40
50
60
70
80
90
100
110