HELIX H1000 Assembly Manual page 9

3 WATER BOTTLE
WATER BOTTLE HOLDER INSTALLATION
1 2
Step 14:
Find the two bolt holes in the Center Upright Post. Locate the 'Step 14' hardware bag that contains the
water bottle bolts (Figure #1)
(Figure #2) Hold the water bottle holder up to the post as shown and install a bolt in the lower hole in the
water bottle holder bracket (Figure #3) and through to the lower bolt hole on the upright.
Do not tighten at this time.
Tilt the water bottle holder upright to align the top hole in the bracket with the top hole on the center
upright post. Install a 2nd bolt into that hole and then tighten with the allen key as shown in Figure #4.
H1000.indd 17-18
PAGE 12
3 4
3 ASSEMBLY - CENTER UPRIGHT TUBE
3
Step 7:
At the base of the main upright connect the wiring harness coming from the upright to the wiring
harness coming from the main body of the Helix Figure #3. After these are connected, tuck the wire and
connection into the upright and be sure the wire is clear of the large gears in the body.
Step 8:
Slide the cover down to the bottom of the center upright tube and fit the tabs into the holes in the lower
plastic housing to fit snuggly in place as shown Figure #4.
Apply only gentle pressure to fit the tabs and the cover in place. Slide the rubber circle down the center
upright tube and push into place as shown. Figure #5 and Figure #6.
5
PAGE 9
4
6
12/04/2016 13:51