HELIX H1000 Assembly Manual page 10

3 ASSEMBLY - HANDLE BARS
1
3
HANDLE BARS INSTALLATION :
Step 9:
Then holding one handlebar in your hand, carefully feed the pulse sensor wire into the upright and out of
the hole at the top of the upright Figure #1 above. Once the wire is out of the top of the upright, remove
one of the temporary bolts and use it to secure the handlebar in place while you prepare to install the
remaining 2 bolts into the handlebar on that side and secure the original long bolt from front to back.
Repeat for the other side as shown above Figure #3.
NOTE
For ease of installation, first install two of the long handlebar bolts temporarily one in each of the
holes shown above the arrow in Figure #2 above.
Step 10:
Place console mounting bracket onto the back of the console threading the wires from the console through
the center square hole. Install 4 console mounting bolts securely but do not overtighten Figure #4.
H1000.indd 19-20
PAGE 10
2
4
3 ASSEMBLY - CONSOLE / COMPUTER
1
Step 11:
Install console with mounting bracket onto the upright as shown in Figure #1 above
Step 12:
Connect 4 wires as shown in Figure #2 above from console to the upright.
COMPUTER INSTALLATION
Step 13:
Once the wires are all connected, gently place the computer onto the mounting plate. Please be extremely
careful not to pinch the wires as the computer is placed down onto the bracket. Once fully onto the bracket,
install the four computer mounting bolts in the four holes on the back of the computer.
Do not over tighten.
Just make them secure.
PAGE 11
2
12/04/2016 13:51