Changing Default Values; Imaging Sequence Examples; Errors While Decoding - Motorola Symbol MS4404 Integration Manual

6 - 2 Symbol MS4404/MS4407 Integration Guide

Changing Default Values

The imager ships with the settings shown in
Standard Defaults
programming is not necessary.
There are two ways to change a parameter value:
•
Capture the appropriate bar codes in this guide. These new values replace the standard default values in
memory.
•
For SSI and USB SNAPI hosts, send a parameter send command from the host system. Hexadecimal
parameter numbers appear in this chapter below the parameter title, and options appear in parenthesis
beneath the accompanying bar codes. Refer to the Simple Serial Interface (SSI) Programmer Guide for
detailed instructions for changing parameter values using this method.
NOTE Most computer monitors allow capturing the bar codes directly on the screen. When capturing from the
screen, be sure to set the document magnification to a level where you can see the bar code clearly, and
bars and/or spaces are not merging.
To return all features to default values, capture
bar code menus, asterisks (

Imaging Sequence Examples

In most cases, capturing one bar code sets the parameter value. For example, to set the beeper tone to high,
capture the High Frequency (beeper tone) bar code listed under
fast warble beep signal and a good decode LED signal, signifying a successful parameter entry.
Other parameters, such as Presentation Mode Session Timeout, require capturing several bar codes. See these
parameter descriptions for this procedure.

Errors While Decoding

Unless otherwise specified, to correct an error during a decoding sequence, just re-capture the correct parameter.
User Preferences Default Table on page 6-3
for all host device and miscellaneous defaults). If the default values suit requirements,
*
) indicate default values.
*
*
Indicates Default
Set Default Parameter on page
High Volume
Feature/Option
(00h)
Option Hex Value for programming
via SSI command
Beeper Tone on page
(also see Appendix A,
6-4. Throughout the programming
6-5. The imager issues a