CHAPTER 2 INSTALLATION
Introduction
This chapter provides information for mounting and installing the SE4710, including physical and electrical
considerations, and recommended window properties for the SE4710.
CAUTION
CAUTION
General Information
Default Power Mode
The default power mode for the SE4710 when connected to a PL3307 decoder is Bus-Powered USB Mode
(<500mA).
If operating in Self-Powered USB Mode (>500mA) or RS-232 Mode with VCC_ILLUM =3.3V, configure the PL3307
for one of these modes using config 0 and config 1 signals.
Electrostatic Discharge (ESD)
Use care when handling this component and apply standard ESD handling procedures such as using grounding
wrist straps and handling in a properly grounded work area.
When handling engines, do not touch the imaging lens. Properly protect fingers to prevent prints on
this lens.
Use care not to touch the Illumination LEDs during handling. Improper handling can damage the LED
lenses.