Removing And Installing The Power Supply - Siemens SIMATIC IPC627D Operating Instructions Manual

Device maintenance and repair
7.4 Removing and installing hardware
7.4.4

Removing and installing the power supply

Requirement
● The device is opened.
Procedure
Removal
1. Remove the screw at the indi-
2. Remove the identified screws
3. Lift up the power supply slightly
4. Lift out the power supply unit completely.
Installation
Proceed in reverse order.
84
cated location below the on/off
switch on the back of the device.
(Torx T10) on the side.
and remove the identified power
supply connector from the power
supply unit.
SIMATIC IPC627D/827D
Operating Instructions, 09/2014, A5E32990859-AB