Notes On The Use Of Third-Party Modules - Siemens SIMATIC IPC627D Operating Instructions Manual

Technical support
A.3 Notes on the use of third-party modules
A.3

Notes on the use of third-party modules

Problem Possible cause
The PC crashes
•
during startup.
•
•
•
168
I/O addresses are assigned
twice.
Hardware interrupts and/or
DMA channels are assigned
twice
Signal frequencies or signal
levels are not adhered to
Different connector pin
assignments
To correct or avoid error
Check your computer configuration:
If the computer configuration corresponds with factory state,
•
please contact your technical support team.
If the computer configuration has changed, restore the
•
original factory settings. Remove all third-party modules,
then restart the PC. If the error no longer occurs, the
third-party module was the cause of the fault. Replace this
module with a Siemens module or contact the module
supplier.
If the PC still crashes, contact your technical support team.
Operating Instructions, 09/2014, A5E32990859-AB
SIMATIC IPC627D/827D