Connecting Ethernet/Usb Strain Relief - Siemens SIMATIC IPC627D Operating Instructions Manual

Document name
S7 CPs for Industrial Ethernet
Configuring and Commissioning
Manual
SIMATIC NET - Twisted Pair and
Fiber-Optic Networks
This documentation is part of the supplied Documentation and Drivers CD:
Operating instructions
CP 1616/CP 1604/CP 1616 onboard
Installation guide
Device Driver CP16xx.sys
Further information
You can find the information on specific products in the Internet at the address: Product-
related Information SIMATIC NET (http://www.siemens.com/simatic-net)
3.3.8

Connecting Ethernet/USB strain relief

The Ethernet/USB strain relief supplied in the product package is used to prevent accidental
removal of the Ethernet cable and Industrial Ethernet FastConnect connector from the
device. You need two cable ties to use the strain relief. In addition to the Ethernet cables,
you can also use this strain relief to protect the four USB cables from inadvertent removal.
To secure the Ethernet strain relief, you will need a TORX T10 screwdriver.
Procedure
1. Secure the Ethernet/USB strain
relief with two oval-head screws
M3
2. Connect the network and USB
cables with the device and secure
the connectors to the strain relief
with cable ties
SIMATIC IPC627D/827D
Operating Instructions, 09/2014, A5E32990859-AB
①
to the device housing.
②
.
Installing and connecting the device
What is contained in this document?
This provides the following support:
- For commissioning S7 stations
- For establishing effective communication
Configure and build your Industrial Ethernet networks
based on this document.
This provides you with all information required for
operation.
Read this guide if you want to install the NDIS device
driver, CP16xx.sys.
3.3 Connecting the device
41