Mitsubishi QJ71C24N User Manual page 241

9 UTILITY PACKAGE (GX Configurator-SC)
9 - 15
POINT
(1) Saving intelligent function module parameters in a file
Since files cannot be saved using the GX Developer project saving operation,
save the files using the "Select a target intelligent function module" screen
shown above.
(2) Reading/writing intelligent function module parameters from/to a
programmable controller using GX Developer
(a) Intelligent function module parameters can be read from and written into a
programmable controller after having been saved in a file.
(b) Set a target programmable controller CPU in GX Developer:
[Online] [Transfer setup].
Perform Write to PLC for the intelligent function module parameters in a
multiple CPU system only to the control CPU of the Q series C24.
(c) Use GX Developer to perform Read from PLC/Write to PLC operations for
the intelligent function module parameters at the remote I/O station.
GX Configurator-SC can not be used.
(3) Checking the required utility
While the start I/O is displayed on the Intelligent function module utility setting
screen, " " may be displayed for the model name.
This means that the required utility has not been installed or the utility cannot
be started from GX Developer.
Check the required utility, selecting [Tools] - [Intelligent function utility] - [Utility
list...] in GX Developer.
MELSEC-Q
9 - 15