Integra DTM-7 Instruction Manual page 41

> Before Start > Part Names
TV/TAPE Set the 12V trigger output setting to each input.
"Off": No output
"Main (default value)": Output when "TV/TAPE" is selected as
input for main room.
"Zone 2": Output when "TV/TAPE" is selected as input for ZONE
2.
"Main/Zone 2": Output when "TV/TAPE" is selected as input for
main room or ZONE 2.
PHONO Set the 12V trigger output setting to each input.
"Off": No output
"Main (default value)": Output when "PHONO" is selected as
input for main room.
"Zone 2": Output when "PHONO" is selected as input for ZONE
2.
"Main/Zone 2": Output when "PHONO" is selected as input for
main room or ZONE 2.
TUNER Set the 12V trigger output setting to each input.
"Off": No output
"Main (default value)": Output when "TUNER" is selected as
input for main room.
"Zone 2": Output when "TUNER" is selected as input for ZONE
2.
"Main/Zone 2": Output when "TUNER" is selected as input for
main room or ZONE 2.
NET Set the 12V trigger output setting to each input.
"Off": No output
"Main (default value)": Output when "NET" is selected as input
for main room.
"Zone 2": Output when "NET" is selected as input for ZONE 2.
"Main/Zone 2": Output when "NET" is selected as input for main
room or ZONE 2.
> Install > Initial Setup > Playback
Advanced Setup
BLUETOOTH Set the 12V trigger output setting to each input.
"Off": No output
"Main (default value)": Output when "BLUETOOTH" is selected
as input for main room.
"Zone 2": Output when "BLUETOOTH" is selected as input for
ZONE 2.
"Main/Zone 2": Output when "BLUETOOTH" is selected as input
for main room or ZONE 2.
∫ 6. 12V Trigger B
Set when outputting the control signal (maximum 12 V/25 mA) through the 12V TRIGGER
OUT B jack. Different settings can be set for each input selector. You can enable power link
operation when you connect the unit and the external devices equipped with 12V trigger
input jack.
Delay Set after how many seconds the 12V trigger output will occur in
response to the unit's operation. As some devices cause a large
current when they turn on, delay the output if such devices are
connected.
Select a value between "0sec" to "3sec". (Default Value is
"1sec")
BD/DVD Set the 12V trigger output setting to each input.
"Off": No output
"Main": Output when "BD/DVD" is selected as input for main
room.
"Zone 2 (default value)": Output when "BD/DVD" is selected as
input for ZONE 2.
"Main/Zone 2": Output when "BD/DVD" is selected as input for
main room or ZONE 2.
CBL/SAT Set the 12V trigger output setting to each input.
"Off": No output
"Main": Output when "CBL/SAT" is selected as input for main
room.
"Zone 2 (default value)": Output when "CBL/SAT" is selected as
input for ZONE 2.
"Main/Zone 2": Output when "CBL/SAT" is selected as input for
main room or ZONE 2.
| Supplementary Information | Others
41
En