Integra DTM-7 Instruction Manual page 40

> Before Start > Part Names
Network Standby When this feature is turned "On (default value)", you can turn on
the power of the unit via the network using an application that
can control this unit.
0 When using "Network Standby", power consumption
increases even when this unit is on standby, however, the
increase in power consumption is kept to a minimum by
automatically entering the Hybrid Standby mode, where only
essential circuits are operating.
0 When the connection to the network is lost, "Network
Standby" is disabled to reduce power consumption. Use the
power button on the remote controller or main unit to turn the
unit on if this happens.
Bluetooth Wakeup This function wakes up the unit on standby by connecting a
BLUETOOTH wireless technology enabled device.
"On": When this function is to be used
"Off (default value)": When this function is not to be used
0 When this setting is turned "On", power consumption
increases even when this unit is on standby, however, the
increase in power consumption is kept to a minimum by
automatically entering the Hybrid Standby mode, where only
essential circuits are operating.
0 The setting is fixed to "Off" if "5. Hardware" - "Bluetooth" -
"Auto Input Change" is set to "Off".
0 Wait for a while if "Network Standby" or "Bluetooth Wakeup" cannot be selected. It will
appear when the network feature is started.
∫ 5. 12V Trigger A
Set when outputting the control signal (maximum 12 V/100 mA) through the 12V TRIGGER
OUT A jack. Different settings can be set for each input selector. You can enable power link
operation when you connect the unit and the external devices equipped with 12V trigger
input jack.
Delay Set after how many seconds the 12V trigger output will occur in
response to the unit's operation. As some devices cause a large
current when they turn on, delay the output if such devices are
connected.
Select a value between "0sec (default value)" to "3sec".
40
> Install > Initial Setup > Playback
Advanced Setup
BD/DVD Set the 12V trigger output setting to each input.
"Off": No output
"Main (default value)": Output when "BD/DVD" is selected as
input for main room.
"Zone 2": Output when "BD/DVD" is selected as input for ZONE
2.
"Main/Zone 2": Output when "BD/DVD" is selected as input for
main room or ZONE 2.
CBL/SAT Set the 12V trigger output setting to each input.
"Off": No output
"Main (default value)": Output when "CBL/SAT" is selected as
input for main room.
"Zone 2": Output when "CBL/SAT" is selected as input for ZONE
2.
"Main/Zone 2": Output when "CBL/SAT" is selected as input for
main room or ZONE 2.
GAME Set the 12V trigger output setting to each input.
"Off": No output
"Main (default value)": Output when "GAME" is selected as input
for main room.
"Zone 2": Output when "GAME" is selected as input for ZONE 2.
"Main/Zone 2": Output when "GAME" is selected as input for
main room or ZONE 2.
PC Set the 12V trigger output setting to each input.
"Off": No output
"Main (default value)": Output when "PC" is selected as input for
main room.
"Zone 2": Output when "PC" is selected as input for ZONE 2.
"Main/Zone 2": Output when "PC" is selected as input for main
room or ZONE 2.
CD Set the 12V trigger output setting to each input.
"Off": No output
"Main (default value)": Output when "CD" is selected as input for
main room.
"Zone 2": Output when "CD" is selected as input for ZONE 2.
"Main/Zone 2": Output when "CD" is selected as input for main
room or ZONE 2.
| Supplementary Information | Others