Troubleshooting flowchart
Figure 12 Troubleshooting LACP MAD failure
Solution
To resolve the problem:
1.
Verify that the intermediate device is an H3C device that supports extended LACPDUs for MAD.
If the intermediate device does not support extended LACPDUs for MAD, replace the intermediate
device, or use BFD MAD for split detection.
2.
Verify that each member device has a link in the link aggregation with the intermediate device.
Verify that the link aggregation is operating in dynamic mode.
3.
To enable dynamic aggregation mode, use the link-aggregation mode dynamic command.
35