Table of Contents
Advertisement
command to verify that the power supply has changed to Normal state. If the power supply
remains in Fault state, go to step b.
b.
Install the power supply into an empty power supply slot. Then execute the display power
command to verify that the power supply has changed to Normal state in the new slot. If the
power supply remains in Fault state, replace the power supply.
4.
If the problem persists, contact H3C Support.
Newly-installed power supply failure
Symptom
A newly-installed power supply fails.
Solution
To resolve the problem:
1.
Execute the display power command to display power supply information.
<H3C> display power
Slot 1
If the power supply is in Absent state, go to step 2. If the power supply is in Fault state, go to step 3.
A newly-installed power supply might run into Absent state when it is not securely installed.
2.
a.
Remove and reinstall the power supply to make sure the power supply is installed securely.
Then execute the display power command to verify that the power supply has changed to
Normal state. If the power supply remains in Absent state, go to step b.
b.
Remove and install the power supply into an empty power supply slot. Then execute the display
power command to verify that the power supply has changed to Normal state in the new slot.
If the power supply remains in Absent state, go to step 4.
3.
Remove and install the power supply into an idle power supply slot. Then execute the display
power command to verify that the power supply has changed to Normal state in the new slot. If the
power supply remains in Fault state, go to step 4.
4.
If the problem persists, contact H3C Support.
Fan tray failure
Symptom
An operating fan tray or a newly-installed fan tray fails.
Power 1
State
: Absent
Power 2
State
: Normal
Type
: AC
9
Advertisement
Table of Contents
Troubleshooting
