Juniper J2300 Quick Start Quide page 5

Table 1: Equipment Required for Services Router Installation
All Models
Electrostatic discharge (ESD)
grounding strap (not
provided)
For rack or wall installation,
a screwdriver appropriate
for the screws or anchors
(not provided)
For AC power, an AC power
cord with a plug appropriate
for your geographical
location (provided)
For DC power, 14 AWG DC
power cables with
appropriate lugs (not
provided)
For grounding, 14 AWG
grounding cable and lug for
the router (not provided)
CAUTION: A licensed electrician must attach a cable lug to the grounding and power
cables that you supply. A cable with an incorrectly attached lug can damage the
router.
If you are installing a J4350 or J6350 Services Router, take the following steps:
1.
Figure 1: Attaching Air Filter and Filter Cover
2.
J2300 Model Only
For desk installation,
four rubber feet
(provided)
For rack installation,
four mounting
screws appropriate
for your rack (not
provided)
For wall installation,
four wall screws or
anchors capable of
supporting the full
weight of the chassis,
up to 12 lb (5.4 kg)
Attach the air filter and filter cover, as shown in Figure 1 on page 5.
Attach the mounting brackets to either the center or front of the chassis, as
shown in Figure 2 on page 6.
All Other Models
For rack installation,
mounting screws
appropriate for your rack
(not provided).
Routers with redundant
power supplies require
an AC power cord
(provided) or DC power
cables (not provided) for
each power supply.
Mounting brackets are
preinstalled on J2320
and J2350 models, and
must be installed on
J4350 and J6350 models.
Before You Begin
Management Access
For CLI access:
Management device,
such as a PC or laptop,
with a serial port (not
provided)
RJ-45 console (Ethernet
rollover") cable, with
an RJ-45-to-DB-9
adapter (both provided)
For J-Web access:
Management device,
such as a PC or laptop,
with an Ethernet port
(not provided)
Ethernet cable (not
provided)
5
Before You Begin