Juniper J2300 Quick Start Quide page 12

J-series Services Router Quick Start
Table 2: J-Web Set Up Quick Configuration (continued)
Field
Domain Search
Default Gateway
Loopback Address
Address
fe-0/0/0
or
ge-0/0/0 Address
Allow Telnet Access
Allow JUNOScript over Clear-Text Access
Allow SSH Access
3.
4.
For complete instructions, see the J-series Services Router Basic LAN and WAN Access
Configuration Guide.
12
Basic Connection and Configuration with the J-Web Interface
Description
Name of each domain to include in a DNS search.
Default route. The IP address of a default router that the Services Router can use
to direct packets addressed to networks not explicitly listed in the routing table.
Reserved IP address that is always available on the router. By default, this address
is set to 127.0.0.1/32
IP address and prefix length of built-in Ethernet port 0. The interface
typically used as the management interface for accessing the router.
ge-0/0/0 is
The DHCP client sets this address to
You must enter the
Up page before you click Apply or OK. If you do not manually configure this address,
the DHCP lease is lost and you will lose your connection to the J-Web interface
when you click Apply or OK.
Enables remote access to the router with Telnet.
Allows JUNOScript to send unencrypted text to the router over a TCP connection.
Enables remote SSH access to the router.
To configure additional interfaces:
Under Quick Configuration, click Interfaces, and then click the interface you
a.
want to configure.
On the Interfaces page, click Add to add a logical interface.
b.
IP addresses are configured on the logical interface.
c. In the two boxes provided, type the IP address (for example,
and the number of bits in the subnet mask (for example,
then click OK or Apply.
To edit an existing interface, you click the logical interface.
To enable routing protocols, under Quick Configuration click Routing.
To add static routes, click Static Routing.
To enable a routing protocol, click the protocol.
When you are finished with a page, click OK or Apply.
.
192.168.1.1/24
or address on the Quick Configuration Set
fe-0/0/0 ge-0/0/0
fe-0/0/0 or
if no DHCP server is found.
192.168.1.4 )
), click Add, and
24