Trouble With Remote Viewing On Browser - COMPRO NC420 User Manual

Trouble with Remote Viewing on Browser

You can view your camera video remotely over the Internet. If you have problem in remote viewing, refer to
the section below for preliminary troubleshooting.
The figure above shows a typical connection setup in which:
• the IP camera has a static virtual IP address of 192.168.0.1
• the WAN IP address at the IP camera site is 61.220.20.16.
• the client (user) is trying to receive the video / audio stream remotely.
To successfully view the live video streamed from the IP camera, you need to:
1. Ensure that the camera's image quality setting stays within the bandwidth limit of your local network.
You can check the camera's image quality setting in [Setup] > [Video]. If your quality setting exceeds
your upload bandwidth limit, you will experience stuttering video or black and blank screen.
2. Check the ports used by the camera in [Setup] > [Network] and note down the HTTP and RTSP server
ports, in this case, ports 80 and 554 respectively.
3. Enable port forwarding on the router and allow traffic on ports the IP camera is using. You may need
to consult the manufacturer of your router for setting details. Note: Your router may require a reboot
after port forwarding is set. The following figure illustrates the settings you need to make in order to
remotely view the IP camera.
Figure 9-8. Remote viewing via browser
Figure 9-9. Advanced network setup
Trouble with Remote Viewing on Browser 9-5
Chapter 9: Troubleshooting