Joining Drill Chuck & Arbor; Lubricating Mill/Drill - Grizzly G0762 Owner's Manual

Joining Drill Chuck
& Arbor
An arbor is included for the drill chuck that
comes with this machine. The following procedure
describes how to install the arbor in the chuck.
After the arbor is installed in the drill chuck, it
is very difficult to separate the assembly. If you
would like to use a different chuck in the future,
we recommend obtaining a new arbor.
Important: DO NOT install the drill chuck and
arbor into the spindle until AFTER the test run.
To join the drill chuck and arbor:
1.
Use mineral spirits to clean drill chuck and
arbor mating surfaces, especially the bore.
2.
Retract chuck jaws completely into chuck.
3.
Insert small end of arbor into chuck.
4.
Hold assembly by arbor and tap chuck onto
a block of wood with medium force, as illus-
trated in Figure 17.
Figure 17. Tapping drill chuck/arbor on block of
wood.
5. Try to separate drill chuck and arbor by hand .
If you can pull them apart, repeat this proce-
dure.
Model G0762 (Mfd. Since 5/14)

Lubricating Mill/Drill

HEADSTOCK MUST
BE FILLED WITH OIL!
OIL MAY NOT BE
SHIPPED WITH MACHINE!
Refer to Lubrication Section
for Correct Oil Type.
The headstock oil reservoir must have the proper
amount of oil in it before the mill/drill can be oper-
ated for the first time. Refer to the Lubrication
subsection, beginning on Page 31, for details on
how to check and add oil.
Damage caused by running the mill/drill
without oil in the reservoir will not be cov-
ered under warranty.
-19-