Use; Cleaning And Maintenance; Cleaning; Optional Accessories - Stanley POP PB3400 Instruction Manual

E N G L I S H
2 . 8 U e s
Place the rivet (fig. 8)
Place the blind rivet (Y) in the nose piece (A)
Position the tool (fig.10)
Switch operation (fig. 9)
Pull and hold the switch (J) until the rivet is fully
set in the application.
If you release the switch (J) before the end of the
setting stroke, the tool will immediately return
to its initial position. If the blind rivet (Y) has not
been set completely, repeat the previous steps.
If the blind rivet (Y) has been set completely,
release the switch (J). The tool will return to its
initial position automatically. The mandrel is auto-
matically dropped into the mandrel collector (X).
Reset function (fig. 9)
If the tool does not move to its initial position after
releasing the switch or stops during the setting
stroke, reset the tool to home by quickly pulling and
releasing the switch (J). If this does not work review
the Troubleshooting Guide.
2 . 9 C e l a n n i g a n
WARNING: Before cleaning and
maintenance, always remove the battery
pack.
Keep the ventilation openings free from dust and
dust and dirt from the ventilation openings.
Emptying the mandrel collector
The mandrel collector must be emptied depending on
the size of the blind rivets used.
Nom. Rivet Dia.
4.8 mm [3/16"]
6.4 mm [1/4"]
Open the mandrel collector (X).
empty the mandrel collector (X).
Close the mandrel collector (X).
14
d M a n i e t n a n e c
Approx. Capacity
200
100
3 . 0 C e l a n n i g
WARNING: Blow dirt and dust out of the
main housing with dry air as often as dirt
is seen collecting in and around the air
vents. Wear approved eye protection and
approved dust mask when performing this
procedure.
WARNING: Never use solvents or other
harsh chemicals for cleaning the non-
metallic parts of the tool. These chemicals
may weaken the materials used in these
water and mild soap. Never let any liquid
get inside the tool; never immerse any part
CHARGER CLEANING INSTRUCTIONS
WARNING: Shock hazard. Disconnect the
charger from the AC outlet before cleaning.
Dirt and grease may be removed from the
non-metallic brush. Do not use water or any
cleaning solutions.
Cleaning the Nose Housing & Jaw Case (fig. 4 & 5)
Loosen the nose housing nut (C). Remove the
nose housing (B).
Press the jaw case lock (W) and loosen the jaw
guide (R). Release the jaw case lock (W).
Remove the jaws (S) and the jaw pusher (T).
Remove the spring (U).
Clean the inside of the nose housing (B) using
a dry cloth.
Clean the clamping jaws (S) and the jaw pusher
(T) using a dry cloth. If necessary, replace the jaws
(S) and the jaw pusher (T).
Clean the pulling head (V) using a dry cloth.
Apply grease to the inside of the jaw guide (R)
where the jaws (S) make contact. A Molybdenum
Disulfide based grease is recommended.
Mount the spring (U).
Mount the jaw pusher (T) and the jaws (S).
Press the jaw case lock (W) and tighten the jaw
guide (R). Release the jaw case lock (W).
D
X
Mount the nose housing (B). Tighten the nose
E
housing nut (C).
3 . 1 O t p o i n l a
WARNING: Since accessories, other than
those offered by POP® have not been tested
with this product, use of such accessories
with this tool could be hazardous. To reduce
the risk of injury, only POP® recommended
A c c s e o s i r s e