Service Kit; Maintenance - Stanley 73200 Instruction And Service Manual

O R I G I N A L I N S T R U C T I O N

6.6 SERVICE KIT

For all servicing we recommend the use of the 73200 Maintenance Kit.
Part Number
07900-01040 AIR PISTON ROD BULLET
07900-01041 BASE PLATE EXTRACTOR
07900-01042 HANDLE RETAINING NUT WRENCH
07900-00043 HEAD PISTON BULLET
07900-01043 HEAD PISTON FRONT SEAL SLEEVE
07900-01044 HEAD PISTON REAR SEAL SLEEVE
07900-01045 HEAD PISTON SEAL GUIDE
07900-01046 HEAD VICE JAW
07900-01047 LIP SEAL HOUSING PUSH ROD
07900-01048 LIP SEAL HOUSING SLEEVE
07900-01049 LOCKNUT SOCKET
07900-01050 REAR LIP SEAL GUIDE
07900-01051 REAR LIP SEAL PLUNGER
07900-01052 REAR PISTON BULLET
07900-01053 RETURN PISTON EXTRACTOR
* Priming Kit 73200-99991 also includes these parts and can be supplied separately.
For servicing the following standard tools are needed (not supplied with Service Kit).
• 4mm Allen key
• 5mm Allen key
• 6mm Allen key
• 10mm Allen key
• 14mm Spanner
• 22mm Spanner or Socket
• 27mm Spanner
• 48mm Spanner
• 10mm PTFE Tape
Spanners and Allen keys are specified across flats unless otherwise stated.

6.7 MAINTENANCE

Annually or every 500,000 cycles (whichever is sooner) the tool should be completely dismantled and new components
should be used where worn, damaged or when recommended. All 'O' rings and seals should be renewed and lubricated
with Molykote® 55m for pneumatic sealing or Molykote® 111 for hydraulic sealing.
WARNING: Read Safety Instructions on page 4 to 6.
WARNING: The employer is responsible for ensuring that tool maintenance instructions are given to the appropriate
personnel.
WARNING: The operator should not be involved in maintenance or repair of the tool unless properly trained.
WARNING: The tool shall be examined regularly for damage and malfunction.
The airline must be disconnected before any servicing or dismantling is attempted, unless specifically instructed otherwise.
It is recommanded to carry out any dismantling operation in clean conditions.
Prior to dismantling the tool it is necessary to remove the nose equipment. For fitting and servicing instructions see page
12 and 15.
For a complete service of the tool, we advise that you proceed with dismantling of sub-assemblies in the order shown.
After any dismantling remember to prime the tool.
The potentially dangerous substances that could have deposited on the machine as a result of work processes must be
removed before maintenance.
Maintenance Kit 73200-99990
Description Part Number
07900-01054 SEAL HOUSING PUSH ROD
07900-01055 SEAL RETAINER WRENCH
07900-00427 SLIDING OFFSET HANDLE
07900-00151 T HANDLE EXTENSION
07900-00692 TRIGGER VALVE EXTRACTOR
07900-00158 2mm PIN PUNCH
07992-00020 GREASE – MOLYLITHIUM EP 3753
07992-00075 GREASE – MOLYKOTE® 55M
07900-00755 GREASE – MOLYKOTE® 111
07900-00756 LOCTITE® 243 THREAD LOCK
07900-01060 * PRIMING SYRINGE (x2)
07900-01061 * PULL STROKE SETTER
07900-01062 * RETURN STROKE SETTER
07900-01063 * PRIMING SYRINGE EXTENSION
07900-01066 STARTER NUT
E N G L I S H
Description
17