Ricoh D197 Service Manual page 1143

SC Tables: SC7xx (Peripherals)
SC No. Level
SC721-03 B
SC No. Level
SC721-10 B
D197/D198/D199/D200/D201/D202
Error Name/Error Condition/Major Cause/Solution
Protection Device Intercept Error 1 (1K sheet finisher)
Fuse blowout is detected

Overload (board defective, harness short-circuit, solenoid
defective)

Replace the main board of the finisher

Replace the harness

Replace the solenoid
Error Name/Error Condition/Major Cause/Solution
Entrance Transport Motor Error (1K sheet finisher)
Motor driver detects an error state (DC motor control error).
1st error detection is determined as a jam and 2nd error
detection is determined as an SC.

Motor defective

Connector disconnected

Overload

Encorder error

Replace the entrance transport motor

Reset the connector

Replace the harness

Replace the main board of the finisher
6-100 SM