Omron V680-HAM91 User Manual page 41

Installation Method
The ID Flag Sensor is to be mounted to a DIN Track. Mount the DIN Track, and then mount the ID Flag
Sensor to the DIN Track.
1. First hook the ID Flag Sensor Unit to part A, then press it in direction B to mount it to the DIN Track.
2. To disconnect the ID Flag Sensor Unit from the DIN Track, pull the mounting hook downwards, and
then lift the Unit upwards.
DIN Track
End Plate
Mounting Hook
Attaching the End Plates:
To mount an End Plate easily, first hook the bottom of the End Plate and then hook the
top on the DIN Track, pull the End Plate downwards and tighten the screw.
Recommended tightening torque: 1.2 N⋅m.
Mounting Interval
The ID Flag Sensor Units will generate heat if they are mounted side-by-
side.
Leave space between Units of at least 10 mm.
Use at least 2 OMRON DIN Track Spacers. (Each Spacer is 5 mm wide）
End Plate
A
DIN Track
PFP-100N2 (OMRON)
B
10 mm min. 10 mm min.
End Plate
Spacer Spacer
Spacer
PFP-S
Installation, Connections, and Wiring
Mounting Hook
End Plate
PFP-M (OMRON)
End Plate
Section 4
RFID System
39
User's Manual