Omron V680-HAM91 User Manual page 22

Section 2
Names and Functions of Components
Access Address Setting Switches
Use these switches to set the memory address for reading data.
Refer to the following figure for a set position
of the Setting Switch.
Cutting edge
Example) When it sets "B".
The setting of the access address setting switches is read only when the power supply is turned ON.
Therefore, settings cannot be changed while the power is being supplied. Turn OFF the power supply before changing
the settings.
Antenna Connector
Connect this connector to the V680-series Antenna (described in this User's Manual).
RFID System
20
User's Manual
Item
Setting
method
Setting
range
Note: The upper 8 bits will not be read if FFFF hex is specified for a16-bit read/
1
2
Specify the memory address of the RF Tag in 4-digit hexadecimal.
Example to specify an RF Tag memory address of 01A3 hex:
"0"
"1"
"A"
"3"
0000 to FFFF hex (See note.)
Default setting: 0000 hex
write operation. All output bits will be OFF.
Pin No. Name
1 S Signal line
2 GND Analog ground
Description
Description I/O
---
---