Replacing The Display Assembly; Procedure; Post-Requisites - Dell Inspiron 17 5000 Service Manual

Replacing the display assembly

WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.

Procedure

1 Place the palm-rest assembly at the edge of a table with the display hinges
facing up.
2 Align the screw holes on the display hinges with the screw holes on the palm-
rest assembly.
3 Replace the screws that secure the display hinges to the palm-rest assembly.
4 Close the display and turn the computer over.
5 Route the antenna cable through the routing guides on the palm-rest assembly.
6 Adhere the tapes that secure the display cable and the antenna cables to the
palm-rest assembly.

Post-requisites

1 Replace the power-adapter
2 Replace the system
3 Replace the heat-sink
4 Replace the I/O
5 Follow the procedure from step 3 to step 8 in
6 Follow the procedure from step 4 to step 7 in
7 Replace the keyboard.
8 Replace the memory
9 Replace the wireless
10 Follow the procedure from step 4 to step 6 in
11 Replace the base
computer. After working inside your computer, follow
After working inside your
port.
board.
assembly.
board.
modules.
card.
cover.
computer. For more safety best
www.dell.com/
"Replacing the computer
"Replacing the optical
"Replacing the hard
Before
base".
drive".
drive".
79