Printer Engine Service Mode - Ricoh A-P4 Service Manual

5. Service Tables

Printer Engine Service Mode

The Printer Engine Service mode is used to check electrical data, change modes, and adjust values.
Here is a quick summary of how to enter and use the Printer Engine Service mode to change the settings
listed in the Service Program Mode Tables.
1. Press and  together, hold down for over 5 seconds, release and then press [#Enter].
or  to display "2.Engine".
2. Press
3. Press [#Enter].
Press  or  to display the SP code groups.
4.
1. Feed
2. Drum
5
3. Process
5. Mode
6. Periphs
7. Data Log
8. Data Log2
9. Etc.
1. Press  or  to select the group, and then press [#Enter].
• The 2-line display is rotational. If you press  with "1.Feed" displayed, the display will jump
to "9. Etc.", the last selection. Similarly, if you press  with "9.Etc" displayed, the display will
jump to "1.Feed", the first selection.
While referring to the Service Program Mode Tables, press  or  to select the SP that you
2.
want to change, and then press [#Enter].
• If you see > or >> to the right of a selection name, this means a menu sublevel exists.
3. Follow one of the procedures below to change a setting.
To change a single-digit number setting:
• Press [#Enter]. A number replaces the cursor.
• Press  or  to increase or decrease the number.
• Press [#Enter]. The number selected on the 2nd line replaces the number above.
184
SP1000
SP2000
SP3000
SP5000
SP6000
SP7000
SP8000
SP9000