Quest Elite 4000 Installation Manual
PRIMING/FLUSHING WATER SYSTEM
To properly prime the unit with water and remove air pockets in the system, open the cabinet door and make sure
that all the valve levers are in the Dispense position.
Close the door and press the dispense button for a few seconds. Repeat until a steady flow of water is observed
from all dispense valves.
NOTE: Some splashing may occur during this purge cycle.
Static Mixer
Dispenser Nozzle
Figure 9. Dispense Nozzle
Publication Number: 620048956INS
- 10 -
© 2010-2016, Cornelius Inc.