Table of Contents
Advertisement
Quick Links
QUEST ELITE 4000/QUEST CAFE
Installation And Operator Manual
QUEST ELITE 4000
QUEST CAFE
Release Date: December 10, 2010
QUEST ELITE 4000 (VERTICAL)
Publication Number: 620048956INS
Revision Date: July 16, 2018
Revision: H
Visit the Cornelius web site at www.cornelius.com for all your Literature needs.
Advertisement
Table of Contents
Related Manuals for Cornelius QUEST CAFE
Summary of Contents for Cornelius QUEST CAFE
- Page 1 Installation And Operator Manual QUEST ELITE 4000 QUEST CAFE Release Date: December 10, 2010 QUEST ELITE 4000 (VERTICAL) Publication Number: 620048956INS Revision Date: July 16, 2018 Revision: H Visit the Cornelius web site at www.cornelius.com for all your Literature needs.
- Page 2 Commercial Warranty. Cornelius will not be responsible for any repair, replacement or other service required by or loss or damage resulting from any of the following occurrences, including but not limited to, (1) other than normal and proper use and normal...
-
Page 3: Table Of Contents
Sanitize the Juice Dispenser ..........14 © 2010-2016, Cornelius Inc. -
Page 4: Safety Instructions
Keep your unit in proper working condition and do not allow unauthorized modifications to the unit. NOTE: The dispenser is not designed for a wash-down environment and MUST NOT be placed in an area where a water jet could be used. © 2010-2016, Cornelius Inc. - 1 - Publication Number: 620048956INS... -
Page 5: Qualified Service Personnel
FAILURE TO COMPLY COULD RESULT IN SERIOUS INJURY, DEATH OR EQUIPMENT DAMAGE. THE APPLIANCE HAS TO BE PLACED IN A HORIZONTAL POSITION Publication Number: 620048956INS - 2 - © 2010-2016, Cornelius Inc. -
Page 6: Unit Dimensions
Quest Elite 4000 Installation Manual UNIT DIMENSIONS Figure 1. Quest Elite 4000 Figure 2 Quest Elite 4000 (Vertical) Figure 3 Quest Cafe © 2010-2016, Cornelius Inc. - 3 - Publication Number: 620048956INS... -
Page 7: Receiving
Four 0.8 gallon (3.0 liter) disposable bottles. NOTE: Refillable Concentrate reservoirs also available. Figure 4. Concentrate Storage Ice Bank/Pull Down Weight 14-16 lbs. (6.35 - 7.25 kg.). Pull Down: 3.5 - 5.5 hours at 75°F (24°C) Publication Number: 620048956INS - 4 - © 2010-2016, Cornelius Inc. -
Page 8: Applications
Staff kitchen areas in shops, offices and other working environments. • Farm houses and by clients in hotels, motels and other residential type environments. • Bed and breakfast type environments. • Catering and similar non-retail applications. © 2010-2016, Cornelius Inc. - 5 - Publication Number: 620048956INS... -
Page 9: Requirements
The Dispenser needs to be placed using 4” legs that are included. MINIMUM 12’’ AIR CLEARANCE AT TOP MINIMUM 4’’ AIR FLOW CLEARANCE AT BACK AND 4’’ AT SIDES Figure 5. Minimum Clearances Publication Number: 620048956INS - 6 - © 2010-2016, Cornelius Inc. -
Page 10: Connecting The Water Supply
2. When securing flare nut, use a backup wrench on the male side of the inlet fitting (unit side) to prevent twisting of the copper tube inside the unit and/or possible damage to the water strainer/solenoid. Water shut off outside the unit is recommended. © 2010-2016, Cornelius Inc. - 7 - Publication Number: 620048956INS... -
Page 11: Filling The Ice Bath
Once the ice bath is full, store the fill tube in the vertically recessed holder. The fill tube can now be used as a “sight glass” to monitor the water level in the ice bath. Publication Number: 620048956INS - 8 - © 2010-2016, Cornelius Inc. -
Page 12: Electrical Requirements
230VAC power supply. 2. 6 ft. long (1.83 m) power cord with 3-prong plug attached to dispenser. Export models are shipped with a Euro- pean plug. © 2010-2016, Cornelius Inc. - 9 - Publication Number: 620048956INS... -
Page 13: Priming/Flushing Water System
Close the door and press the dispense button for a few seconds. Repeat until a steady flow of water is observed from all dispense valves. NOTE: Some splashing may occur during this purge cycle. Static Mixer Dispenser Nozzle Figure 9. Dispense Nozzle Publication Number: 620048956INS - 10 - © 2010-2016, Cornelius Inc. -
Page 14: Brixing Procedure
• 1 - Thermometer • 1 - Refractometer • 1 - Flat Bladed Screwdriver NOTE: The refractometer shown is P/N 511004000, and is available through your local Cornelius Distributor. BRIX S HECKING DJUSTING THE ETTING The following instructions are for use with a refractometer. - Page 15 Additionally, prior to taking your next BRIX reading, momentarily press the corresponding dispense button several times prior to drawing a sample. This clears any remnants from the dispense nozzle and helps move the flow control to its new setting. Publication Number: 620048956INS - 12 - © 2010-2016, Cornelius Inc.
-
Page 16: Programming The Portion Control
Figure 11. Control Panel UTTON To pour a drink without using a pre-programmed portion control size, simply push and hold the Stop button. Release when the glass is full. © 2010-2016, Cornelius Inc. - 13 - Publication Number: 620048956INS... -
Page 17: Clean Splash Zones And Dispense Nozzles
Place the mixing chambers, nozzles, and static mixers in a separate container of sanitizing solution and agitate vigorously. Allow the parts to soak for two minutes, then rinse thoroughly with fresh tap water. Reinstall the static mixer, nozzles and mixing chambers. Publication Number: 620048956INS - 14 - © 2010-2016, Cornelius Inc. - Page 19 Cornelius Inc. www.cornelius.com...