Programming The Portion Control; Stop Button - Cornelius QUEST ELITE 4000 Installation Manual

PROGRAMMING THE PORTION CONTROL

If the dispenser has optional portion controls, they have been pre-programmed from the factory to pour 7, 12, and
16 ounce drinks. The "extra large" (pitcher icon) size has also been pre-programmed to pour 16 ounces.
To change the pour sizes, please perform the procedure described in .
Step
1
2
3
4
S B
TOP UTTON
To pour a drink without using a pre-programmed portion control size, simply push and hold the Stop button.
Release when the glass is full.
© 2010-2016, Cornelius Inc.
Simultaneously, press and hold Small and Extra Large buttons on
the Portion Control Module until the Refill light starts blinking.
Release the buttons. The blinking Refill light indicates the program-
ming mode is active. See . Control Panel.
Place a cup under the dispense nozzle and push the selected size
button (small, medium, large, or extra large). Hold the button in until
the cup fills to the desired portion, then release the button. Repeat
the procedure for the remaining sizes.
After programming all the drink sizes, press and release the Stop
button to return the Portion Control to the operational mode. The
blinking REFILL light goes off.
In the future, to change the portion size of the drinks, the individual
sizes can be adjusted by performing Step 2. It is not necessary to
reprogram every size. Additionally, the portion control has full mem-
ory retention in case of a power failure.
Figure 10. Control Panel
Table 1.
Action
- 11 -
Quest Elite 4000 Installation Manual
Publication Number: 620048956INS