Filling The Ice Bath - Cornelius QUEST ELITE 4000 Installation Manual

Quest Elite 4000 Installation Manual
The ice bath holds approximately 3.5 gallons (13.4 liters) of water. The fill tube is located behind the front splash
plate and capped with a 0.5" plug.
1. Remove the 0.5" plug and attach the tube to any one of the dispense nozzles.
2. Open the door and verify that the flush/dispense lever is in the dispense mode. (see Figure 6) Ice
bath must always be filled in the dispense mode.
NOTE: Non flush units does not have a flush/dispense lever hence for filling water bath on non
flush units please remove the concentrate Storage bottles first and then attach the tube to
any one of the dispense nozzles and Close the door, press and hold the dispense button
(push) until the tank is filled and water trickles from the overflow
Water Bath
Water Bath
Fill Tube
Connection
3. Close the door, press and hold the dispense button (push), shown in . Dispense Buttons, until the
tank is filled and water trickles from the overflow.
4. Once the ice bath is full, store the fill tube in the vertically recessed holder. The fill tube can now be
used as a "sight glass" to monitor the water level in the ice bath.
Publication Number: 620048956INS

FILLING THE ICE BATH

Water Bath
Fill Tube
Overflow
Figure 6. Water Bath and Dispense/Flush Lever
Figure 7. Dispense Buttons
Dispense/Flush
Lever
- 8 - © 2010-2016, Cornelius Inc.