Connecting The Water Supply; Electrical Requirements - Cornelius QUEST ELITE 4000 Installation Manual

CONNECTING THE WATER SUPPLY

The Quest Elite series Juice Dispenser is designed to dispense juice at a high flow rate. It is very important that the
incoming water line be dedicated for use by the dispenser only and does not have other machines connected which
could cause a water surge, (i.e., a dishwasher, coffee maker, etc.).
!
IMPORTANT:
The water supply should be consistent with proper water quality standards (neutral pH of 7.0 to 8.0), and
should not be connected to a water softener. It is the installer's responsibility to ensure that all water
connections to the dispenser are sized, installed with adequate backflow protection and maintained to
comply with Federal, State, and Local Laws.
1. Secure the 3/8" (0.95 cm) swivel nut on the flexible supply tubing to the water inlet located at the rear
of the dispenser. Make sure that the flared gasket is used (flared gasket P/N 311304000 is included
with the installation kit).
2. When securing flare nut, use a backup wrench on the male side of the inlet fitting (unit side) to prevent
twisting of the copper tube inside the unit and/or possible damage to the water strainer/solenoid.
Water shut off outside the unit is recommended.

ELECTRICAL REQUIREMENTS

A minimum of 15 amps electrical service is needed for 120VAC power supply. A minimum of 10 amps electrical
service is needed for 230VAC power supply.
© 2010-2016, Cornelius Inc.
Water Inlet
with Supply Tubing
Connected
Figure 8. Water Supply Connection on Rear of Unit
- 9 -
Quest Elite 4000 Installation Manual
Publication Number: 620048956INS