Removing The Ignition Key-Switch When On *Off*; Removing The Ignition Key-Switch When On *Lock*; Taillight Assy. - PIAGGIO Liberty 125 Workshop Manual

Liberty 125 - 200 4tempi

Removing the ignition key-switch when on *off*

• Remove the shield back plate
• Push the lock body until the stop spring does not
show grooves.
• Keep the lock body blocked with a screwdriver
and remove the spring with a pair of pliers.
• Take out the lock block.
See also
Knee-guard

Removing the ignition key-switch when on *lock*

Remove the shield.
- Remove the switch of the key switch.
- Make a hole on the block using a drill as shown
in the figure.
- Insert the wheel cylinder with the key and with the
anchoring tab facing down halfway on the lock
body taking care that the insertion phase of the key
is oriented matching "ON" (the only position that
enables the cylinder to get into the lock body); now
turn the key leftwards to "OFF" and at the same
time press until the cylinder is completely in.

Taillight assy.

• To remove the taillight and position light or the 2
turn signals, just unscrew the screws located on
the related light covers and disconnect the electri-
cal connections.
N.B.
REMOVAL OF THE REAR LIGHT BULBS IS ONLY POSSI-
BLE BY REMOVING THE LIGHT COVERS ROTATING
THEM 30° ANTI-CLOCKWISE.
Chassis
CHAS - 159