Line Voltage Requirements; Power Supply Location; Power Cords Requirements - Amana ARR6300 Series Owner's Manual

Line Voltage Requirements

Line voltage must not exceed rated voltage. Line voltage
less than rated voltage will result in slow heating. Wiring
system must conform to Underwriters Laboratories, Inc.
standards and National Electrical Code. Installation must
conform to all local, municipal and state building codes,
and local utility regulations. Range must be connected only
to a supply circuit as specified on rating plate wiring diagram
of range.
This range requires 3 wires, 120/240 Volts, 60 Hertz A.C.
See rating plate attached to range for kilowatt rating.
House wiring and fusing must comply with local wiring
codes. If no codes apply, wire according to National
Electrical Codes.

Power Supply Location

Shaded areas show range clearance for electrical
connection.
A
B
A—3 inches
B—7 inches
C—6 inches
D—30 1 / inches minimum
8
E—24 1 /
16
A
E
C
D

Power Cords Requirements

Power cord is not supplied with range. Power cord must
be U.L. Listed and meet NEC and Mobile Home
Manufacturers Association Standards. Cord must be
rated at a minimum 250V - 50 AMP, equipped with a plug
configuration in accordance with NEMA and conductors
must end with closed loop (ring) terminals at the range.
• Three-conductor cord plug NEMA 10-50P allowed
for residential.
• Four-conductor cord plug NEMA 14-50P required for
most mobile home installations but can be used for
residential.
Range has been grounded at the factory to the center
(nickel plated) terminal of the terminal block in
accordance with the National Electrical Code (section
2560). When a separate ground is required by local code,
disconnect the grounding strap from the terminal block.
Ground frame by connecting a grounding wire to range
frame using only the grounding screw removed from the
grounding strap.
7