Fuse Replacement - DAELIM Q2 Owner's Manual

CAUTION
When using the battery without cover,
●
(+), (-) terminals may be connected to
cause short circuit resulting in fire.
When handling the battery, stay away
from flammable materials.
Your battery is a maintenance-free type
●
so check or refilling of electrolyte will
not be required. If there is any
abnormal, contact to Daelim service
center.
If you reform the battery for car, battery
●
will be improperly installed to cause
short circuit resulting in fire.
If the electrolyte gets into your eyes or
●
on skin, it'll cause a serious injury.
Do not discard the battery other than
●
specified place. It will bring
environmental contamination, and be
brought under the law
40

FUSE REPLACEMENT

Turn off the main switch to see if the fuse
is severed. If the fuse is severed, exchange
the fuse into a fuse with same
capacity.(15A)
Fuse is installed in fuse holder around
●
the battery.
To change a fuse, first take off fuse
●
holder. Then, remove the disconnected
fuse, and insert the reserved fuse with
same capacity.
BATTERY
If the fuse immediately becomes severed after
●
being changed with the new one, check another
problem of the electric system. Contact to the
designated service shop.
(Out of order in the charging system, the wires
being taken off, bad connection of connector)
DISASSEMBLY
Disassemble by pulling
out from the upside
FUSE BOX
30A
FUSE A
15A
FUSE B
15A
FUSE C
15A
FUSE D
15A
FUSE E
ASSEMBLY
Press and assemble
from the upside
CHARGING, COMBI. S/W,
REGULATOR
WINKER RELAY, METER
LIGHTING, HORN HEAD LIGHT (HI
/ LOW), FR/RR. STOP SWITCH,
TAIL LIGHT, FUEL METER
IGNITION COIL, ECU, OXYGEN
SENSOR
ECU, FUEL PUMP RELAY
FAN MOTOR