Table of Contents
Advertisement
Heat Controller
INSTALLATION INSTRUCTIONS
Wall Sleeve Brands:
4
8
3
4
2
Room Air Conditioner with R-410A
4
8
3
4
#1 Emerson - 15" Deep
#1 Emerson
1. Remove existing rear grille as shown on Page 6
1. Remove existing rear grille as shown on Page
of this manual and replace with provided louvered
6 of this manual and replace with provided
rear panel. Install as shown here.
louvered rear panel. Install as shown here.
NOTE: You may need to drill holes in flange of
NOTE: You may need to drill holes in flange of
existing sleeve to match new rear grille.
existing sleeve to match new rear grille.
2. Attach(1) 1" x 3/8" x 25" long seal in the center at
the top of the sleeve. Remove the backing paper
2. Attach(1)1 x 3/8 x 25 long seal in the center at
and press into position.
the top of the sleeve. Remove the backing paper
3. Attach the (2) 1" x 3/8" x 14" long seals to the
and press into position.
left and right sides of the sleeve.
3. Attach the (2) 1 x 3/8 x14 long seals to the
left and right sides of the sleeve.
4. Cut (2) 1" x 3/8" x 25" long seals to 14" long,and
4. Cut (2) 1 x 3/8 x 25 long seals to 14 long,and
attach it to the vertical sections of the rear grille
attach it to the vertical sections of the rear grille
as shown.
as shown.
5. Attach (2) 4-1/2" x 3-1/2" x 1-1/2" centering/support
5. Attach (2)4 x3
1
/
1
/
2
blocks one on each side wall. Place in center of
one on each side wall. Place in center of side
side wall with the tapered end facing the opening.
wall with the tapered end facing the opening.
6. Gently slide unit into sleeve.
6. Gently slide unit into sleeve.
7. Before sliding all-the-way back, remove 2nd
7. Before sliding all-the-way back, remove 2nd
screw from front on left side of unit.
screw from front on left side of unit.
8. Remove the plastic washer from the screw.
8. Remove the plastic washer from the screw.
9. Screw and attach the other end of the ground
9. Screw and attach the other end of the ground
wire to the unit as shown in picture. Make sure
wire to the unit as shown in picture. Make sure
that the toothed washer is against the cabinet.
that the toothed washer is against the cabinet.
10.Slide the unit completely to the rear to ensure
10. Slide the unit completely to the rear to ensure
a good seal, making sure the ground wire does
a good seal, making sure the ground wire does
not become tangled.
not become tangled.
11.Seal & Frame the unit as described on page 17.
11. Seal & Frame the unit as described on page 17.
12. If you have difficulty with mounting the grill to
12. If you have difficulty with mounting the grill to the
the sleeve, follow the instructions for direct
sleeve, follow the instructions for direct mounting
mounting on Page 16.
on Page 16.
8
Owner's Manual
15 Deep
x1
centering/support blocks
1
/
2
2
Hide quick links:
Advertisement
Table of Contents
