Heat Controller BG-103M Owner's Manual page 14

Owner's Manual
INSTALLATION INSTRUCTIONS
Wall Sleeve Brands:
4
4
4
Room Air Conditioner with R-410A
4
8 8
3
3
4
5
#6 Whirlpool - 17-1/8" Deep
#6 Whirlpool
1. Remove existing rear grille as shown on Page 6 of
this manual and replace with provided louvered rear
1. Remove existing rear grille as shown on Page
panel. Install as shown here.
6 of this manual and replace with provided
louvered rear panel. Install as shown here.
NOTE: you may need to drill holes in flange of
existing sleeve to match new rear grille.
NOTE: You may need to drill holes in flange of
existing sleeve to match new rear grille.
2. Cut (2) 17" Tapered Spacer Blocks as shown
below into two pieces.
2. Cut (2) 17 Tapered Spacer Blocks as shown
below into two pieces.
3 /
Tapered Spacer Block
4
Cut Here
3. Install 13" section to the floor of the sleeve as
3. Install 13 section to the floor of the sleeve as
shown. This helps induce a rearward slope on the
shown. This helps induce a rearward slop on the
unit.
unit.
4. Attach (1) 1" x 3/8" x 25" long seal in the center at
4. Attach (1)1 x3/8 x25 long seal in the center
the top of the sleeve. Remove the backing paper and
at the top of the sleeve. Remove the backing
press into position.
paper and press into position.
5. Attach (2) 1" x 3/8" x 14" seals to the left and right
5. Attach (2) 1 x3/8 x14 seals to the left and
sides of the sleeve. right sides of the sleeve.
6. Cut (2) 1 x3/8 x25 long seals to 14 long
6. Cut (2) 1" x 3/8" x 25" long seals to 14" long and
and attach it to the vertical sections of the rear
attach it to the vertical sections of the rear grille as
grille as shown.
shown.
7. Center unit and gently slide unit into sleeve.
7. Center unit and gently slide unit into sleeve.
8. Before sliding all-the-way back, remove 2nd
8. Before sliding all-the-way back, remove 2nd screw
screw from front on left side of unit.
from front on left side of unit.
9. Remove the plastic washer from the screw.
9. Remove the plastic washer from the screw.
10. Screw and attach the other end of the ground
10. Screw and attach the other end of the ground wire
wire to the unit as shown in picture. Make sure
to the unit as shown in picture. Make sure that the
that the toothed washer is against the cabinet.
toothed washer is against the cabinet.
11.Slide the unit completely to the rear to ensure
11. Slide the unit completely to the rear to ensure a good
a good seal, making sure the ground wire does
seal, making sure the ground wire does not become
not become tangled.
12.Seal & Frame the unit as described on page 17. tangled.
12. Seal & Frame the unit as described on page 17.
13. If you have difficulty with mounting the grill to
the sleeve, follow the instructions for direct
13. If you have difficulty with mounting the grill to the
mounting on Page 16.
sleeve, follow the instructions for direct mounting on
Page 16.
13
Heat Controller
17 Deep
1 8 /
17
1
13
Protection Paper
Backing