Heat Controller BG-103M Owner's Manual page 16

Owner's Manual
INSTALLATION INSTRUCTIONS
Wall Sleeve Brands:
4
3
4
2
Room Air Conditioner with R-410A
4
8 8
3
4
3
4
#8 White Westinghouse/Frigidaire/Carrier
#8 White Westinghouse/Frigidaire/
Carrier 52F Series ( 16 +17 Deep)
52F Series - (16" + 17-1/2" Deep)
1. Remove existing rear grille as shown on Page 6 of
1.Remove existing rear grille as shown on Page this manual and replace with provided louvered rear
6 of this manual and replace with provided
panel. Install as shown here.
louvered rear panel. Install as shown here.
NOTE: you may need to drill holes in flange of exist-
NOTE: You may need to drill holes in flange of
ing sleeve to match new rear grille.
existing sleeve to match new rear grille.
2. Attach (1) 1" x 3/8" x 25" long seal in the center at
the top of the sleeve. Remove the backing paper
and press into position.
2. Attach (1)1 x3/8 x25 long seal in the center
3. Attach (2) 1" x 3/8"x 14" seals to the left and right
at the top of the sleeve. Remove the backing
sides of the sleeve.
paper and press into position.
4. Attach (2) 1" x 3/4" x 14" long seals vertically 4.5
3. Attach (2) 1 x3/8 x14 seals to the left and
right sides of the sleeve. from the left side of the sleeve .Attach the other
4. Attach (2) 1 x3/4 x14 long seals vertically 4.5
1" x 3/4" x 14" long seal 4 from the right side of the
from the left side of the sleeve .Attach the other
sleeve.
1 x3/4 x14 long seal 4 from the right side of the
5. Center unit and gently slide unit into sleeve.
sleeve.
6. Before sliding all-the-way back, remove 2nd screw
5. Center unit and gently slide unit into sleeve.
from front on left side of unit.
6. Before sliding all-the-way back, remove 2nd
7. Remove the plastic washer from the screw.
screw from front on left side of unit.
8. Screw and attach the other end of the ground wire
7. Remove the plastic washer from the screw.
to the unit as shown in picture. Make sure that the
8. Screw and attach the other end of the ground
toothed washer is against the cabinet.
wire to the unit as shown in picture. Make sure
9. Slide the unit completely to the rear to ensure a
that the toothed washer is against the cabinet.
good seal, making sure the ground wire does not
9. Slide the unit completely to the rear to ensure
become tangled.
a good seal, making sure the ground wire does
10. Seal & Frame the unit as described on page 17.
not become tangled.
10.Seal & Frame the unit as described on page 17.
11. If you have difficulty with mounting the grill to the
11. If you have difficulty with mounting the grill to sleeve, follow the instructions for direct mounting on
the sleeve, follow the instructions for direct
Page 16.
mounting on Page 16.
15
Heat Controller
/
1
2