Heat Controller BG-103M Owner's Manual page 12

Owner's Manual
INSTALLATION INSTRUCTIONS
Wall Sleeve Brands:
4
4
4
Room Air Conditioner with R-410A
4
8 8
3
3
4
5
#4 General Electric/Hotpoint - 16-7/8" Deep
#4 General Electric/Hotpoint 16
1. Remove existing rear grille as shown on Page 6 of
this manual and replace with provided louvered rear
1. Remove existing rear grille as shown on Page
panel. Install as shown here.
6 of this manual and replace with provided
louvered rear panel. Install as shown here.
NOTE: you may need to drill holes in flange of
NOTE: You may need to drill holes in flange of
existing sleeve to match new rear grille.
existing sleeve to match new rear grille.
2. Cut (2) 17" Tapered Spacer Blocks as shown
below into two pieces.
2. Cut (2) 17 Tapered Spacer Blocks as shown
below into two pieces.
3 /
Tapered Spacer Block
4
3. Install 13" section as shown with the tapered end
3. Install 13 section as shown with the tapered end
from the back of the sleeve. This helps induce a rear-
from the back of the sleeve. This helps induce a
1 /
ward slope on the unit. 2
rearward slop on the unit.
4. Attach (1) 1" x 3/8" x 25" long seal in the center at the
4. Attach (1)1 x3/8 x25 long seal in the center
top of the sleeve. Remove the backing paper and press
at the top of the sleeve. Remove the backing
into position.
paper and press into position.
5. Attach (2) 1" x 3/8" x 14" seals to the left and right sides
5. Attach (2) 1 x3/8 x14 seals to the left and
of the sleeve.
right sides of the sleeve.
6. Cut (2) 1 x3/8 x25 long seals to 14 long
6. Cut (2) 1" x 3/8" x 25" long seals to 14" long and attach it
and attach it to the vertical sections of the rear
to the vertical sections of the rear grille as shown.
grille as shown.
7. Center unit and gently slide unit into sleeve.
7. Center unit and gently slide unit into sleeve.
8. Before sliding all-the-way back, remove 2nd screw from
8. Before sliding all-the-way back, remove 2nd
front on left side of unit.
screw from front on left side of unit.
9. Remove the plastic washer from the screw.
9. Remove the plastic washer from the screw.
10. Screw and attach the other end of the ground wire to
10. Screw and attach the other end of the ground
the unit as shown in picture. Make sure that the toothed
wire to the unit as shown in picture. Make sure
washer is against the cabinet.
that the toothed washer is against the cabinet.
11. Slide the unit completely to the rear to ensure a good 11.Slide the unit completely to the rear to ensure
a good seal, making sure the ground wire does
seal, making sure the ground wire does not become
not become tangled.
tangled.
12.Seal & Frame the unit as described on page 17.
12. Seal & Frame the unit as described on page 17.
13. If you have difficulty with mounting the grill to
13. If you have difficulty with mounting the grill to the sleeve,
the sleeve, follow the instructions for direct
follow the instructions for direct mounting on Page 16.
mounting on Page 16.
11
10
17
1
Cut Here
13
Protection Paper
Backing
Heat Controller
7 8 / Deep