Table of Contents
Advertisement
set port redundancy {enable | disable}
User level: privileged, supervisor.
Use the set port redundancy {enable | disable} command to globally
enable or disable the port redundancy pairs you have defined. This command does not delete
the existing redundancy entries from NVRAM.
Syntax:
The syntax for this command is:
set port redundancy {enable | disable}
Example:
W310-1# set port redundancy enable
All redundancy schemes are now enabled
Related Commands:
•
Use the
•
Use the
redundancy pairs defined for the switch.
set port redundancy
User level: privileged, supervisor.
Use the set port redundancy command to define or remove redundancy pairs. A
port redundancy member can be any port (including LAG logical port) that is not a member
of a LAG or another redundancy pair.
Avaya W310 Command Reference Guide
set port redundancy
show port redundancy
command to define or remove redundancy pairs.
command to display information about the port
Chapter 11
279
Advertisement
Table of Contents
